Hi All
I would like to implement the equivalent of the following program code snippet on the TI Nspire CX CAS.
The problem being the Dialog command is not on the Nspire.
Is there a way it could be re-coded to suit the Nspire?
Thank you for any suggestions you may have
Regards
tgahan
Code:
I would like to implement the equivalent of the following program code snippet on the TI Nspire CX CAS.
The problem being the Dialog command is not on the Nspire.
Is there a way it could be re-coded to suit the Nspire?
Thank you for any suggestions you may have
Regards
tgahan
Code:
Prgm
Local a
Dialog
Title "Options"
Dropdown "Choose one", {"perimeter","area", "lateral area", "volume"}, a
EndDlog
if a = 1 then
// do this
ElseIf a=2 then
// do something old
ElseIf a=3 then
// do something borrowed
ElseIf a=4 then
// do something new
EndIf
EndPrgm