After getting CBLLight mostly ported to TI-84 Plus C SE, I am left with a bug in drawing data values to the graph.
In this case L₁ is an int(265/S)-element list, where S is the width in pixels of each data value in L₁.
Code:
Although the 84+ version of this code acts normally, on the 84C it results in the data lines appearing wider than 1 pixel, which I somewhat expected but still need fixed. How would I make these lines 1 pixel thick?
In this case L₁ is an int(265/S)-element list, where S is the width in pixels of each data value in L₁.
Code:
:dim(L1)→Z
:For(Y,1,264) //264 is pixels, not list location values
:If iPart(X)≤Z
:Line(Y,0,Y,L₁(iPart(X
:X+S⁻ยน→X //Adds part of a pixel to S every time a pixel location (Y) is incremented
:End
Although the 84+ version of this code acts normally, on the 84C it results in the data lines appearing wider than 1 pixel, which I somewhat expected but still need fixed. How would I make these lines 1 pixel thick?