If I want to take the L and R from a 3.5mm audio jack, and merge the connections, I need to add in some resistors right?
Resistors shouldn't be necessary if you're just converting stereo to mono. All you have to do is connect the left and right wires together.
Or you could treat one of the sides as ground and leave the real ground wire disconnected so you get a mono signal that is the difference of the two channels. But that's probably not what you want to do.
Or you could treat one of the sides as ground and leave the real ground wire disconnected so you get a mono signal that is the difference of the two channels. But that's probably not what you want to do.
I was talking to a friend, and he said if there are no resistors there could be a short. I don't understand how though, because if hooked together, the LR are both flowing in the same direction.
@Comic
That is exactly what I would like to do;
@Chris
Thanks
@Comic
That is exactly what I would like to do;
@Chris
Thanks
joshie75 wrote:
I was talking to a friend, and he said if there are no resistors there could be a short. I don't understand how though, because if hooked together, the LR are both flowing in the same direction.
Well, technically it is a short - but that's what you want.
I never thought of that being a short. But yes I can confirm crossing the left and the right wires and then connecting those to a speaker + and the ground to a speaker - does work.
It is a short because you are crossing your hot and cold lines, which is technically, a short, although a non harmful one.
iirc
iirc
joshie75 wrote:
I was talking to a friend, and he said if there are no resistors there could be a short. I don't understand how though, because if hooked together, the LR are both flowing in the same direction.
Your friend is mistaken. The resistors won't prevent the current flowing backwards, just attenuate it. Not to mention decreasing the volume on both channels.
I'd personally connect a smallish resistor and capacitor to each side (left and right) and join those together to avoid putting undue strain on the amplifiers.
Code:
I use a similar circuit (albeit with much larger resistors) to mix stereo to mono and to attenuate the signal so I can use it to connect audio output to a microphone input.
Code:
0.1uF
L o--[100R]---||---.
+---o Out
R o--[100R]---||---'
0.1uF
I use a similar circuit (albeit with much larger resistors) to mix stereo to mono and to attenuate the signal so I can use it to connect audio output to a microphone input.
Now as Kerm mentioned earlier, wouldn't those resistors lower the volume on the channels? Do the capacitors just make sure there is no backwards flow, if not, what do the caps. do?
joshie75 wrote:
@Kerm;
The current flowing backwards, that won't harm the input device, right?
The current flowing backwards, that won't harm the input device, right?
Where is this "backwards flow" stuff coming from?
Well there is none, I thought Kerm was saying backwards flowing current can be prevented. I looked at my circuit and there is no backwards flowing current so I'm good there.
Register to Join the Conversation
Have your own thoughts to add to this or any other topic? Want to ask a question, offer a suggestion, share your own programs and projects, upload a file to the file archives, get help with calculator and computer programming, or simply chat with like-minded coders and tech and calculator enthusiasts via the site-wide AJAX SAX widget? Registration for a free Cemetech account only takes a minute.
» Go to Registration page
» Go to Registration page
Page 1 of 1
» All times are UTC - 5 Hours
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum
Advertisement