how exactly can i set up chaos assembler so that i can actually use it? when i try to run it i get a message that says that is a privaleged command. and it also resulted in me having to redownload and install ti-connect because i could no longer send .83p files to my calculator.
i was going to use it though because it was recommended by zappi for creating the sprites. unless you know of a really good sprite editor that i could use instead.
lafferjm wrote:
can you please provide link i searched ticalc.org and could not find it.
http://www.ticalc.org/archives/files/fileinfo/132/13274.html 
Chaos only work on windows 98 or older. it never worked on 2000 and XP for any of the 35 computers i tried it on (32 from school+3 of my own)
Register to Join the Conversation
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum
Advertisement